Product Overview
QwikBright®-MC
QT2782
Don’t just clean your microchannel coil, protect it... with QwikBright®-MC. A clogged
or dirty condenser coil can reduce eciency of the unit, increase the pressure ratio of
the compressor, accelerate corrosion and reduce the sub-cooling... but, you must be
careful when cleaning microchannel coils.
Microchannel coil manufactures recommend only cleaning with a pH neutral
cleaner and NEVER using any acidic or alkaline cleaner since any cleaner with a pH
below 6 (acidic) or above 8 (alkaline) can dramatically accelerate corrosion and result
in coil leaks.
QwikBright®-MC is a neutral pH microchannel coil cleaner and protectant that
is specially formulated to quickly penetrate and dissolve grease, dirt, grime, lint,
dirt, dust, and bugs without removing any existing protective lm while adding an
additional protective lm. That’s right, QwikBright®-MC contains a molecular metal
protectant to further prevent corrosion without degrading thermal performance.
QwikBright®-MC may be used indoors or outdoors on any type of microchannel
heat exchanger and when used on evaporators, no rinsing is required.
100010859 / MKTG000234_REV-C
by Mainstream Engineering Corporation®
QwikBright®-MC
by Mainstream Engineering Corporation®
Mainstream Engineering Corporation®
1-800-866-3550
www.qwik.com
For more details or information about QwikBright®-MC visit www.qwik.com
MADE IN THE U.S.A.
QwikProducts®, and QwikBright® are registered trademarks
of Mainstream Engineering Corporation. Rockledge, Florida 32955, (321) 631-3550
X Specially formulated for all aluminum microchannel heat exchangers
X Neutral pH
X Heavy Duty Foaming Action
X Improves Coil Eciency
X Includes Metal Protectant to Extend Life
X For Indoor or Outdoor Use
X Super Concentrated... Mix 1 part QwikBright®-MC
with 4 to 8 parts water
Microchannel Coil Cleaner & Protectant
DIRECTIONS FOR USE
1. Always wear goggles, gloves, impervious
protective clothing and a full face shield.
2. Make certain the unit is o and disconnected.
3. Mix to the recommended dilution, depending on the soil level of the coil and apply
with a low-pressure sprayer. NEVER USE FULL STRENGTH. Minimum dilution is
1 part QwikBright®-MC to 4 parts water. Add water to the sprayer rst then add
QwikBright®-MC to the water.
4. Spray the QwikBright®-MC and water solution onto the dirty microchannel coil and
allow QwikBright®-MC to remain in contact with the dirty surfaces for 5 – 10 minutes.
5. For condensers, rinse thoroughly
with clean water. For evaporators, no
rinsing is required.
MIXING CHART
Light Soil 1 part QwikBright®-MC to 8 parts water
Medium Soil 1 part QwikBright®-MC to 6 parts water
Heavy Soil 1 part QwikBright®-MC to 4 parts water