Install Instructions

Ideally, the QwikPure TripleGuard™ Air Purier should be located in the center of the

air ow of the duct, that is midway between the sides of the duct.

The QwikPure TripleGuard™ must be installed into the ductwork in a location that

cannot be viewed by anyone during routine operation of the system or during air

lter changing. LOOKING DIRECTLY AT AN ILLUMINATED UNIT WILL CAUSE

DAMAGE TO EYES. The GREEN LED indicates the unit is powered and operating

properly and the two ORANGE LEDs indicate each UV-C bulb is operating properly.

There is never a need to look at the UV-C bulbs during operation.

Step 4. Install the Mounting Bracket

If the QwikPure TripleGuard™ unit is to be installed against a sheet metal surface,

skip tto Step 5.

If the QwikPure TripleGuard™ is to be installed into duct board, then the mounting

ange must be installed rst, to provide a solid anchoring method for the QwikPure

TripleGuard™ unit.

a. Prepare to cut an opening in the duct board for insertion of the QwikPure

TripleGuard™ unit.

1. Position and hold the mounting ange against the duct board (studs pointing

toward the duct board), and orient to preferred mounting point.

2. Apply enough pressure to cause the mounting plate studs to dent/mark the

duct board to allow accurate holes to be created.

3. Remove the mounting ange temporarily. Locate the stud marks and use a drill,

a sharp pointed object, or the threaded studs of the mounting ange to punch

the holes in the duct board for the ange mounting studs.

4. Align the mounting plate studs with the created holes and insert until the

mounting plate is ush with the duct board.

5. Cut an opening along the inside opening of the ange as shown in Figure 1.

Before cutting, ensure the QwikPure TripleGuard™ will t in the planned

space.

b. Insert the mounting ange through the opening in the duct board, locate the

mounting ange on the inside of the duct board, align the mounting ange

studs to holes, push studs through and bolt the mounting ange to the duct board

using the center ¼-20 threaded studs, washers and ¼-20 nuts. Use a wrench to

tighten both threaded fastners so the duct board is slightly compressed and the

mounting ange is secure.

Qwik

Pure

TripleGuard™

Industrial Grade Air Sanitizer

9.1”

Figure 1