Operation Manual

44
Display & Controls: Midmotor models
Selecon eld
The following informaon can be seen in the ‘selecon
eld’ of the display. You can switch through the
dierent types of informaon by pressing the ‘LOGO’
buon. The following informaon can be seen if the
selected language is set to English.
RPM: Revoluons Per Minute, show the current
cadence (revoluons of the pedals). When the RPM
is shown you can also see an up or down arrow. This
shows in which direcon you could shi gears for a
beer system eciency.
Tip: Both you, as user, and the motor perform most
eciently between 55 and 80 rpm. On those pedal
speeds the least amount of enery will be lost, and the
motorpower and range are opmal.
CLOCK: Shows the clock, this can be set to 12 hour or
24 hour format.
DISTANCE: The total distance travelled since the last
RESET.
RIDETIME: The total me travelled since the last
RESET.
AVERAGE: The average speed, this is calculated as
the total distance travelled divided by the total me
travelled (since the last RESET).
MAXIMUM: Shows the maximum speed since the last
RESET.
ODOMETER: The total distance travelled.
BOOST: The walk-assist mode, which is in use as long
as the ‘PLUS’ or ‘MINUS’ buons are pressed. The walk-
assist knows a speed of around 5 km/h. This funcon
may only be used when you are pushing the bicycle.
RESET: If you press the ‘MINUS’ buon at the reset
selecon, all the data of DISTANCE, RIDETIME, AVERAGE
and MAXIMUM will be reset to 0. Reseng is only
possible when the bicycle is in standsll.