Operation Manual
40
Display & Controls: Rearmotor models
Controlling the Walk Assist
Use the Walk Assist feature to easily take the bicycle
by the hand, for example when taking it out of
underground storage. Stand rmly next to the bike and
hold your hands on the handlebars. If a brake lever is
present, keep at least one hand on the brake where
the brake-circuit breaker (interrupon of the motor
assistance) is located.
This is generally is the le brake lever. Keep the ‘PLUS’
buon pressed while rmly holding the handlebars. The
engine will start aer a few seconds. Once you release
the ‘PLUS’ buon the Walk Assist funcon switches
itself o. The Walk Assist has a speed of 3 km/h. The
Walk assist can only be used in assistance level 1 - 8.
(Screen) Lighng
Press the ‘ON/OFF’ buon to turn on the
(screen) lighng. Press ‘ON/OFF’ again to turn it o
again. When you turn on the screen lighng, the front
and rear lights will automacally turn on as well. They
work on the baery as well, so no extra baeries are
required.
USB connecon
The USB connecon on the back of the display can be
used to provide power to devices such as smartphones
and navigaon devices. It can also be used when the
system is o, if the baery is sll on the bike.
Tire size
Set the correct re size (mm) by pressing the ‘SET’
buon for 10 seconds. The pre-set sizes may deviate a
lile. This means that the amount of driven kilometers
has a maximum deviaon of 5%.
16 inch Circumference: 1272 mm
20 inch Circumference: 1590 mm
24 inch Circumference: 1907 mm
26 inch Circumference: 2070 mm
28 inch standard re Circumference: 2224 mm
28 inch balloon re Circumference: 2268 mm
Switch o
Press the ‘ON/OFF’ buon for 2 seconds to turn o
the system. The control panel can only be used when
the baery is connected to the bike. If the display is
turned o while riding the bike, or when riding without
baery, it is possible that random values are displayed
as the motor generates small powerstreams. Everything
that appears on the display when the system is not
acvated, can be ignored.