Operation Manual

45
NEDERLANDSDEUTSCH ENGLISH
Display & Controls: Midmotor models
Display sengs
Press the ‘ON/OFF’ buon on the back of the display for
5 seconds to open the ‘sengs’ menu. Use the ‘PLUS’
and ‘MINUS’ buons to adjust the sengs per menu
and press the ‘LOGO’ buon for 1 second to conrm
the seng and connue to the next seng opon.
Seng opons in the seng menu:
Language
Choose from: NL (Dutch), EN (English), DE (German), FR
(French), IT (Italian), ES (Spanish).
Clock
First, you can adjust the 12 or 24 hours display format
with the ‘PLUS’ and ‘MINUS’ buons. You can conrm
the seng by shortly pressing the ‘LOGO’ buon. Then,
you can adjust the me with the ‘PLUS’ and ‘MINUS’
buons. Shortly pressing the ‘LOGO’ buon toggles
between hours / ten minutes / minutes.
By pressing the ‘ON/OFF’ buon you will leave the
sengs menu.
Failure codes
When ‘ERR’ appears in the screen, there is an error
with the speed sensor. Check if the speed sensor at the
rear wheel is adjusted correctly. The magnet may be a
maximum of 15 mm away from the sensor and needs to
be at either one of the two notches.
If a motor symbol with ‘HOT’ appears in the top le of
the screen, the temperature of the motor is too high.
Let the motor cool down. Cooling down of the motor
is also possible by connuing to cycle without motor
assistance.
If ‘CHANGE DISPLAY BATTERY’ appears in the screen
aer switching it on, you can change the baery of
the display. For this you need to remove the 4 phillips
screws on the back of the display, aer which you
can turn the baery cap open with a (new) baery.
The baery is of the type CR2032. Aer replacing the
display baery you can screw the parts back together
as they were. For removing the display from the handle
bars it is not neccessary to remove other parts (grip or
brakes) from the handle bars.
It is possible that other problems occur. In that case,
be in contact with your dealer soon so that a potenal
repair can be executed fast.