Operation Manual
83
NEDERLANDSENGLISHDEUTSCH
General components of the electric bicycle
Brakes
First things rst
To prevent any surprises while driving, please
familiarize yourself which side brake lever is for which
brake (front or rear wheel). It is important to never use
any grease or cleaning agents on braking pads or rotors.
Grease and other contaminants can cause noise while
braking and diminish braking funcon.
Hydraulic Disc brakes
Disc brakes combine high braking power with a high
level of control. The brake pads of the hydraulic disc
brakes can be adjusted by slightly loosening the Allen
bolts of the caliper mount. Center the caliper while
pulling the brake levers rmly. Tighten the screws rmly
when you are done adjusng.
Noise complaints when braking
Brakes can resonate while braking. When new braking
pads are installed, it is important to properly bed in
braking pads. This will reduce noise complaints and also
increase the durability of your pads greatly.
To bed in new braking pads, nd a safe environment
and built up some speed (around 25 km/h). Now brake
a lile bit for 5-6 seconds, just enough that the pads
are in contact with the rotor. Then pull the brake levers
more rmly and slow down to about 5 km/h. With
the brake levers sll slightly pulled, speed up again to
25 km/h. Repeat 10-15 mes to fully bed in the new
pads. Remember to not fully brake to standsll at once
without releasing the brake levers, this might cause
damage to the rotor. Bed in the front and rear pads
separately.