Operation Manual

61
NEDERLANDSENGLISHDEUTSCH
Display & Controls: Mid-drive motor models
Other system sengs such as the re size can only be
adjusted by connecng the system to a computer. Your
dealer can do this for you.
Error codes
Your bike has been equipped with a self-diagnosis tool
to nd possible problems early. In case an error has
been reported by the system an error code will be
displayed in the informaon eld in the boom. An
oen occuring problem with e-bike systems is a low
baery, which can be indicated by the following error
codes:
Code 10, 12 or 24
Check if the baery is properly charged.
It is possible that other errors are detected in the
system, or that the above instrucons do not help.
In this case, please contact your dealer.
System sengs
Set the me
When the clock is displayed, press and hold the
‘
’ buon for 2 seconds to adjust the me. Use
the ‘ ’ and ‘ ’ buon to adjust the me and press
the ‘ ’ buon to conrm.
Reset the trip informaon
Reset the trip informaon by selecng any trip info in
the informaon eld and holding the ‘ ’ buon
for 2 seconds.
Automac light switch
Press and hold the ‘ ’ buon for 2 seconds to
acvate or deacvate the automac light funcon.
When acvated, the light sensor will noce when it gets
dark and will acvate the lights.
Change unit seng (km/h - mph)
Turn o the display by pressing the ‘ ’ buon
briey. Then push and hold both the ‘ ’ buon
and the ‘ ’ buon for at least 3 seconds unl the
soware version appears on the display screen. The unit
sengs have now been changed. Repeat these steps to
change the unit seng back.