Operation Manual

57
NEDERLANDSENGLISHDEUTSCH
Display & Controls: Mid-drive motor models
Range indicator
Your e-bike system is equipped with range calculaon.
Based upon the remaining charge of the baery and
the current power usage of the motor, the system
automacally makes a calculaon what distance the
motor can cover before you run out of power. If you
set the power mode to a lower level, you will noce
the range increases; as a lower power level will use less
power, you will get further with the same charge.
System sengs
System sengs such as the re size or distance
unit sengs (km/h - mph) can only be adjusted by
connecng the system to a computer. Your dealer can
do this for you.
Maintenance
To make sure you can enjoy your e-bike for a long
me, it is important to schedule regular maintenance
and replace wear sensive parts on me. To help
you remind this, the maintenance symbol will appear
at a regular interval on your display. Make sure you
schedule maintenance at a QWIC approved point of
service.
Error codes
Your bike has been equipped with a self-diagnosis tool
to nd possible problems early. In case an error has
been reported by the system the maintenance symbol
on the display will be accompanied by an error code in
the journey data eld (right boom corner). The most
occurring errors can oen be solved by yourself:
Code 48 - Speedsensor error
The speed is monitored by a small magnet on the rear
wheel and a sensor on the frame. Please check if the
magnet is sll aligned with the sensor.
Code 64, 66 of 67 - Low baery signal
Check if the baery is properly charged.
It is possible that other errors are detected in the
system, or that the above instrucons do not help.
In this case, please contact your dealer.