Operation Manual

53
NEDERLANDSENGLISHDEUTSCH
Display & Controls: Rearmotor models
Error codes
It is possible that failures occur. If this happens, go to
the dealer as soon as possible so repairs can be carried
out quickly. The following codes can be displayed on
the display:
Error 1: Problem with 3-phase control from the
controller
Error 2: Problem with throle connecon (start-
detecon)
Error 3: Motor cable 3-phase wiring loose or defecve
Error 4: Motor cable Hall Sensor signal malfuncon
(malfuncon in motor or motor cable)
Error 5: Malfuncon in brake sensor(signal)
Error 6: Baery voltage too low
Error 7: Motor stalled
Error 8: Malfuncon in controller (signal)
Error 9: Malfuncon in display (signal) and/or
torque/rotaon sensor (signal)
SET 2: Seng the re size
Set the correct re-size for more exact informaon on
the screen. On the side of every re you can nd the
size. The default sizes may deviate a lile. This means
that the amount of driven kilometres has a maximum
deviaon of 5%.
The default seng for your QWIC bike is:
28 inch 40-622 Circumference: 2205 mm
SET 3: (Speed) Units
With the ‘PLUS’ and ‘MINUS’ buons you can switch
between kilometres (per hour) and miles (per hour).
SET 4: Baery informaon
With the ‘PLUS’ and ‘MINUS’ buons you can see the
following informaon of the baery: the percentage of
the remaining battery capacity, the total charging cycles
and the actual battery voltage.
SET 5: Maintenance
(Re)set a warning to remind you to get a maintenance
check-up.
SET 6: Soware version
Displays the current soware version of the display.