Operation Manual

Controlling the Walk Assist
Use the Walk Assist feature to easily take the bicycle
by the hand, for example when taking it out of
underground storage. Stand rmly next to the bike and
hold your hands on the handlebars. If a brake lever is
present, keep at least one hand on the brake where
the brake-circuit breaker (interrupon of the motor
assistance) is located. This is generally is the le brake
lever. Keep the ‘PLUS’ buon pressed while rmly
holding the handlebars. The engine will start aer a few
seconds. Once you release the ‘PLUS’ buon the Walk
Assist funcon switches itself o. The Walk Assist has a
speed of 6 km/h (no load).
Bicycle lights
Press the ‘ON/OFF’ buon to turn on the bicycle lights.
Press ‘ON/OFF’ again to turn it o again.
USB connecon
The USB connecon on the back of the display can be
used to provide power to devices such as smartphones
and navigaon devices. It can also be used when the
system is o, if the baery is sll on the bike.
Reseng the Trip data
By pressing and holding the ‘MINUS’ buon for two
seconds you can reset the trip distance. This also
resets the logged maximum speed and mer. If the trip
distance reaches the 500 km it will be automacally
reset.
Sengs menu
By pressing and holding the ‘SET’ buon for 2 seconds
you can open the sengs menu. By pressing ‘SET’
shortly you can switch between the dierent sengs,
with the ‘PLUS’ and ‘MINUS’ buons you can changes
the values. Leave the sengs menu by holding ‘SET’
buon.
SET 1: Seng the Driving-mode
Please note: Opon only availible on P-MN7 / P-MN360
With the ‘PLUS’ and ‘MINUS’ buons you can adjust the
driving-mode. Not every cyclist is the same. One likes a
powerful support where someone else prefers an extra
high range. Therefore the display has 3 dierent driving
modes that inuence the motorpower:
ECO: Extra high range, less motorpower
NORMAL: Average range, average motorpower
POWER: Extra motorpower, lower range