Operation Manual

Error codes
It is possible that failures occur. If this happens, go to
the dealer as soon as possible so repairs can be carried
out quickly. The following codes can be displayed on
the display:
Error 1: Problem with 3-phase control from the
controller
Error 2: Problem with throle connecon (start-
detecon)
Error 3: Motorcable 3-phase wiring loose or defecve
Error 4: Motorcable Hall Sensor signal malfuncon
(malfuncon in motor or motorcable)
Error 5: Malfuncon in brake sensor(signal)
Error 6: Baery voltage too low
Error 7: Motor stalled
Error 8: Malfuncon in controller (signal)
Error 9: Malfuncon in display (signal)
SET 2: Seng the speedlimiter
Please note: Opon only availible on P-RD9(s)
With the ‘PLUS’ and ‘MINUS’ you can adjust the
speedlimiter. With this you can limit the maximum
speed in which the motor provides power. This can be
handy if you prefer to drive on lower speeds.
SET 3: Seng the Tire-size
Set the correct re-size for more exact informaon on
the screen. On the side of every re you can nd the
size. The pre-set sizes may deviate a lile. This means
that the amount of driven kilometers has a maximum
deviaon of 5%.
The default seng for your QWIC bike is:
28 inch 40-622 Circumference: 2205 mm*
SET 4: (Speed) Units
With the ‘PLUS’ and ‘MINUS’ buons you can switch
between kilometers (per hour) and miles (per hour).
SET 6: Baery informaon
Please note: Opon only availible on P-MN7 / P-MN360
With the ‘PLUS’ and ‘MINUS’ buons you can see the
following informaon of the baery: The percentage of
the remaining battery-capacity, the total charging-cycli
and the actual battery voltage.