Specifications

9
Getting started
Your phone can operate up to four handsets. To order additional handsets call the supplier.
Register your accessory handsets
1. After charging the battery, the screen will display:
2. On the base unit, press MENU/SEL, then scroll to DISPLAY BASE ID,
press MENU/SEL.
3. Enter the 15 digit base unit ID code, If you make a mistake, press the
DELETE/MUTE key to backspace (delete characters), then enter the
correct information.
4. Press MENU/SELECT to complete the registration process.
5. Once a valid base ID code has been entered, the display will blank for
a second or two, and then show:
6. If the base accepts the new handset, after several seconds the new
handset will show:
Where X is the new handset number assigned, sequentially, by the base.
Re-register existing handsets to a new base
1. Install your new base unit, the handset(s) will display SEARCHING…,
press and hold the MENU/SELECT button for two seconds.
2. The handset will display:
3. Follow steps 2 through 6 in Registration above.
De-register all system handsets
1. With the phone in idle, press *883244# on the base.
2. Then press MENU/SEL, IN USE and CHARGE, the POWER LED will
illuminate briey before returning to idle.
3. This will erase all handsets registered to the base. The handsets will
now prompt you to:
4. Re-register the handset(s) to base by following steps 2 through 6 in
Registration above.
Registration
ENTER BASE ID
###############
SEARCHING...
HANDSET X
ENTER BASE ID
###############
• The 15-digit base
ID code may
contain numbers
and characters,
including 0
through 9 and *.
Make sure you
enter all 15 digits.
• If you do not
enter the correct
digit sequence,
you will hear an
error tone. Press
DELETE/MUTE
key to backspace
to erase a
character(s) and
carefully re-enter
the base ID code.
• De-registering all
system handsets
will prevent any
handset from
placing calls until
the handset is
re-register to the
base.
ENTER BASE ID
###############