User manual

1. Connect your VGA source, audio source, infrared and RS-232 devices to the VAS-E transmitter.

2. Connect your VGA display, audio speaker, infrared and RS-232 devices to the VAS-E receiver.

3. Connect a Cat-5e / 6 cable between the VAS-E transmitter and VAS-E receiver.

4. Make sure this Cat-5e / 6 cable is tightly connected and not loose.

5. Plug in 5V DC power supply unit to the power jack of the VAS-E receiver.

6. Plug in 5V DC power supply unit to the power jack of the VAS-E transmitter.

7. If you see the monitor is displaying blurred video or even worse, not displaying at all, please

adjust the EQ and Gain rotary controls to improve the cable skew. GAIN rotary control is to

adjust the gain to an appropriate level for a range of input signal levels (brightness), and EQ

rotary control is to equalize the wave form of the receiving video signal (sharpness). It is

suggested to begin with adjusting the rotary control of EQ to get the input video displayed

first, and then the rotary control of GAIN according to the video you see on the screen.

NSTALLATION