User`s manual

Server
The parameters below ONLY pertain to the operation of the QVidium H.264 HD Video Codec™
with a QVidium QoS Proxy Server. Leave this disabled when not connecting to a QoS Proxy
Server.
This feature allows the decoder to initiate and receive a unicast stream from a QoS Proxy Server.
You must provide the IP address and control port for the QoS Proxy Server. The decoder then
sends a control packet upstream to the server when you start the decoder.
Use Server: Select No to disable this feature. Select Yes to enable operation with a QoS Proxy
Server.
IP Address or Hostname: Enter the IP address of the QoS Proxy Server to which the decoder will
send a start-stream message.
Echo Port: Normally, this should be left to the default UDP port 7. This port number must match
the value at the QoS Proxy Server. In addition, you may need to configure a firewall at the server
to allow ingress for packets on this port.