User`s manual

User’s Manual v.13 QVidium
®
H.264 HD Video Codecs™
Copyright 2011-2013 QVidium
®
Technologies, Inc. Page 52 of 67
1. First eliminate any network problems by connecting the encoder and decoder to the same
Ethernet switch. Use CodecManager, running on a PC also connected to that switch, to
verify that the IP and MAC addresses are all different.
2. Click on Defaults on the Encode and Decode sides to reset all your profile settings to their
factory default values.
3. Verify that the Destination IP address and port specified on the encoder match their
configured values on the decoder. For unicast, leave the “multicast address” blank on the
decoder. For Multicast, make certain that you have specified the same multicast address
on the decoder as well as on the encoder. If multicasting through a router, make certain
that the router supports IGMP v3 and that it is enabled.