User`s manual

User’s Manual v.13 QVidium

H.264 HD Video Codecs™

Technologies, Inc. Page 16 of 67

Simplified Encoder Configuration

(QVENC and QVPRO Only)

The encoder is configured and operated from a web browser. These settings are stored in non-

volatile flash memory, allowing the QVPRO to recover after a power failure. This section serves as a

simplified Quick-Start guide for fast and easy configuration of the encoder. For mode complete

control of the encoder and access to the full range of encoder functionality, please see

Section 3:

Complete Encoder Configuration

1. Enter http://<IPAddress>/encode where <IPAddress> is the IP address of the

QVidium QVPRO that you want to configure. For example: http://192.168.1.23/encode if using

the default address. Use username encode, and the password for the admin user (default:

admin). (You can change this password from the main System/Password menu.)

2. Select the Video Input (SDI or HDMI for QVPRO, SDI, Composite, or S-Video for QVENC).

Enter the desired Stream Bit Rate. (We recommend 4000000 for SD and 8000000 for HD

video.) Enter the IP address of the decoder for the Destination IP address. Enter the UDP

port. (We recommend 10000.)

3. Confirm that the input is active and connected and that the appropriate Link Light is lit on the

front and then click on Start.

For troubleshooting or verifying that the encoder has started properly, please log in to the main

codec control menu using the instructions in the next section. From that main codec control menu,

you can click on

Encoder/Status

to check the outgoing bitrate. If you suspect a problem, then

please click on

Encoder/Show Log