Installation Sheet

2of2
2018 QuoizelInc.
ReleasedDate:2018-09-12
visit us on-lineat www.quoizel.com
STEP 5 - Wire Connections
A. Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
B. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
Green Ground Screw
on the Crossbar
White wire
from outlet box
White wire
from fixture
Black wire from
outlet box (or Red)
Black wire
from fixture
Bare, or Green
Ground wire
from outlet box
Ground wire
from Fixture
STEP 6 Install the Fixture-
A. Carefully tuck all wires into the outlet box and position the ceiling
canopy and Fixture Body (B) over the outlet box. Align the holes in
the ceiling canopy with the mounting screws, then attach the
ceiling canopy and Fixture Body (B) using the previously removed
mounting balls. Hand tighten until snug.
STEP 7 - Install Bulbs
A. Insert bulbs onto sockets and screw snugly into place.
Your fixture is now assembled and ready to use. Enjoy!
T8 Vintage Bulb
(Recommended
but not included)
Socket
(Step 4 Continued)
snug against the ceiling not, adjust the
length of the nipple on the Crossbar Assembly (A) by unscrewing
the preassembled hex nut and lock washer and then screwing the
mounting screws in or out of the crossbar until the correct length is
achieved. Once the ceiling canopy is secure, remove the mounting
ball and Fixture Body (B).
and the mounting balls. If
Figure 5
Mounting Screw
Mounting Ball
A
Ceiling Canopy
Figure 6
Figure 7
VC1716MB
FINISH: MOTTLED BLACK
16” Dia.
14.5”
5.5” Dia.
NOTE: ALL DIMENSIONS ARE ROUNDED UP TO THE NEAREST 1/4"