Installation Sheet

2of2
TRA1719PK
FINISH: POLISHED NICKEL
Figure 6
STEP 6 Install the Fixture-
A. Carefully tuck all wires into the outlet box and position the Fixture
Canopy over the outlet box. Align the holes in the ceiling canopy
with the mounting screws, then attach the Fixture Canopy using the
previously removed mounting balls. Hand tighten until snug.
NOTE: ALL DIMENSIONS ARE ROUNDED UP
TO THE NEAREST 1/4"
2018 QuoizelInc.
visit us on-line at www.quoizel.com
ReleasedDate:2018-11-05
5” Dia.
16.5”
18”
STEP 7 Install the Bead String Assembly-
A. Place the loop on the end of all Bead Strings (D) to the bottom hooks
on fixture body (B).
b. Place bead strings one next another. Attach the hook on the end of
the Bead String (D) to the loop at the bottom edge of the support
Ring (C).
c. Place the cap (F) over the nipple extruding from the fixture body (B).
Secure with the glass accent (E). Hand-tighten until snug.
STEP 5 - Wire Connections
A.
B. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
Figure 5
Green Ground Screw
on the Crossbar
White wire
from outlet box
White wire
from fixture
Black wire from
outlet box (or Red)
Black wire
from fixture
Bare, or Green
Ground wire
from outlet box
Ground wire
from Fixture
STEP 8 Install the Bulb-
A. Insert the bulb onto the socket and screw snugly into place.
Your fixture is now assembled and ready to use. Enjoy!
Figure 8
Bulb(not included)
Mounting Screw
Mounting Ball
A
Fixture Canopy
Loop
D
E
Hook
Hook
Loop
B
C
F
Nipple
Figure 7