Installation Sheet

2of2
STEP 5 Install the Fixture-
A. Carefully tuck all wires into the outlet box and position the ceiling
canopy and Fixture Body (C) over the outlet box. Align the holes in
the ceiling canopy with the mounting screws, then attach the ceiling
canopy and Fixture Body (C) using the previously removed
mounting balls. Hand tighten until snug.
Figure 5
STEP 4 - Wire Connections
A. Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
B. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
Figure 4
Green Ground Screw
on the Crossbar
White wire
from outlet box
White wire
from fixture
Black wire from
outlet box (or Red)
Black wire
from fixture
Bare, or Green
Ground wire
from outlet box
Ground wire
from Fixture
STEP 6 Install Bulbs-
A. Insert bulbs onto sockets and screw snugly into place.
2018 QuoizelInc.
ReleasedDate:2018-08-15
visit us on-line at www.quoizel.com
Mounting Screw
Mounting Ball
A
C
Ceiling
Canopy
Vintage Bulb
(Recommended
but not included)
Socket
C
Figure 6
STEP 7 - Install Cage
A. Place the Cage (D) onto the ceiling canopy and align holes on the
top edge of the Cage (D) to mounting holes on the ceiling canopy.
Secure by threading Lock Screws (F) into mounting holes. Hand
tighten until snug.
Your fixture is now assembled and ready to use. Enjoy!
Ceiling Canopy
Mounting Hole
F
D
Hole
Figure 7
SCR1614OZ
FINISH: OLD BRONZE
NOTE: ALL DIMENSIONS ARE ROUNDED UP
TO THE NEAREST 1/4"
14.25” Dia.
10” Dia.
5.75”
2.75”
6.5”