Installation Sheet

2of2
STEP 5A - Wire Connections
A.
B. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
Figure 6
STEP 6A Install the Fixture-
A. Carefully tuck all wires into the outlet box and position the Ceiling
Canopy (D) over the outlet box. Align the holes in the ceiling canopy
with the mounting screws, then attach the Ceiling Canopy (D) using
the previously removed mounting balls. Hand tighten until snug.
STEP 7A Install the Bulb-
A. Insert the bulb onto the socket and
screw snugly into place.
Your fixture is now assembled and
ready to use. Enjoy!
Figure 5
Green Ground Screw
on the Crossbar
White wire
from outlet box
White wire
from fixture
Black wire from
outlet box (or Red)
Black wire
from fixture
Bare, or Green
Ground wire
from outlet box
Ground wire
from Fixture
Figure 7
2018 QuoizelInc.
visit us on-line at www.quoizel.com
Mounting Ball
A
D
Bulb (not included)
Assembly Instructions for Pendant Light
STEP 2B - Install Ceiling Canopy, Rods and
Fixture Body together
a. Determine the Rods (B/C) to be assembled to
the Fixture Body (E) according to your hanging
height.
b. Pass the supply wires and ground wire through
the chosen rods (B/C) and the Ceiling Canopy.
Thread the Fixture Body (E), the chosen Rods
(B/C) and the Ceiling Canopy together. Hand
tighten until snug.
Suggested rods for Ceiling height :
8’ ceiling : use (1) 6” rods and (1) 12” rods
9’ ceiling : use (1) 6” rods and (2) 12” rods
B
Supply Wires
and Ground Wire
E
C
Figure 2
B
C
Ceiling Canopy
After completing Step 7B refer to the Steps
2A to 6A to complete the installation.
16”
8”
46.25”
5” Dia.
PENDANT LIGHT
SEMI-FLUSH
16”
5” Dia.
12”
NOTE: ALL DIMENSIONS ARE ROUNDED UP TO THE NEAREST 1/4"
STEP 1B Install Ceiling Canopy to Fixture Body-
a. Pass supply wires and ground wire through the Swivel (F) and the
Ceiling Canopy (D).
b. Thread the Swivel (F), the Ceiling Canopy (D) and the Fixture Body
(E) together as shown. Tighten the set screw on the swivel (F).
E
D
F
Screw
ReleasedDate:2018-09-19
RDE1716AWN
FINISH: AGED WALNUT