Installation Sheet

Package Contents
Warnings and Cautions
1of2
For Style PCSS1616C
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Pleasegoto forproductcleaningtips.Gotothe selection.
markingpen,1/ ”
drillbit,
IntegratedLED28W
20-30minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtoensureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactyouroriginalplaceofpurchase.
www.quoizel.com Care+Maintenance
LightSource:
EstimatedAssemblyTime:
Preparation:
ToolsRequired: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses, 4
.
Fixture Body
x1
F
Installation Guide #IS-PCSS1616C
2018 QuoizelInc.
ReleasedDate:2018-08-15
visit us on-line at www.quoizel.com
B
Inner Backplate
x1
A
Mounting Screw
x4
E
C
Wall Anchor
x4
D
Screw
x4
Washer
x4
GN
D
STEP 1 - Attach Inner Backplate to Outlet Box
A. Attach the Inner Backplate (A) onto the outlet box and make four
marks on the ceiling from keyholes.
B. Remove the Inner Backplate (A). Using a 1/4” drill bit, drill holes at
each (4) locations marked on the ceiling.
C. Insert Wall Anchors (C) into drilled holes completely.
D. Pass supply wires and ground wire through the center hole of the
Inner Backplate (A). Attach the Inner Backplate (A) to outlet box.
Thread outlet box screws (not included) into mounting holes on the
outlet box. Pass Washers (E) over Screws (D) and thread Screws (D)
into Wall Anchors (C). Hand tighten until snug with screwdrivers.
Outlet Box
E
D
C
A
Supply Wires
with Ground Wire
Outlet Box Screws
(not included)
Figure 1
Keyhole
STEP 2 - Attach the Lanyard
A. The purpose of the lanyard is to provide a means to support the
fixture hands free from the junction box while connecting the
electrical wires.
B. Turn the Button Stop so it may be inserted into a inner backplate slot.
Make sure the Button Stop is completely inside the inner backplate.
Slowly release the fixture to make sure it is supported by the Button
Stop. Proceed to the wiring steps in the next step. Once you are
complete with the wiring, the Lanyard will push into the junction box
when the fixture is placed for final mounting.
Button Stop
Lanyard
Slot
A
Figure 3
STEP 3 - Wire Connections
A. Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
B. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
Figure 2
Green Ground Screw
on the Crossbar
White wire
from outlet box
White wire
from fixture
Black wire from
outlet box (or Red)
Black wire
from fixture
Bare, or Green
Ground wire
from outlet box
Ground wire
from Fixture