Installation Sheet

Package Contents
1of2
For Style PCOH1716OI
A
Crossbar
x1
Pleasegoto forproductcleaningtips.Gotothe selection.
LED24W
20-30minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtoensureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactyouroriginalplaceofpurchase.
www.quoizel.com Care+Maintenance
LightSource:
EstimatedAssemblyTime:
Preparation:
ToolsRequired:Flatheadscrewdriver, Phillips screwdriver,pliers,wirecutters,wirestrippers,electricaltape,safetyglasses.
Installation Guide #IS-PCOH1716OI
2019 QuoizelInc.
ReleasedDate:2019-03-15
visit us on-line at www.quoizel.com
Mounting Screw
x2
B
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Fixture Body
x1
C
Figure 1
STEP 1 - Install the Crossbar to the junction box
A. Attach the Crossbar (A) to the outlet box with the head of the green
ground screw facing you. Secure it with outlet box screws (not
included), tighten until snug.
Outlet Box
Outlet Box Screws
(not included)
A
Green Ground Screw
STEP 2 - Wire Connections
A. Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
B. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
Green Ground Screw
on the Crossbar
White wire
from outlet box
White wire
from fixture
Black wire from
outlet box (or Red)
Black wire
from fixture
Bare, or Green
Ground wire
from outlet box
Ground wire
from Fixture
Supply Wires and
Ground Wire
STEP 3 - Install the Fixture Body to Crossbar
A. Place the ceiling canopy onto the Crossbar (A) and align the holes
on the ceiling canopy to mounting holes on the side of the
Crossbar (A). Secure the ceiling canopy and Fixture Body (C) to
the Crossbar (A) with Mounting Screws (B). Hand tighten until
snug with screwdrivers.
Your fixture is now assembled and ready to use. Enjoy!
A
B
C
Figure 3
Figure 2
Outlet Box
Ceiling Canopy