Installation Sheet

Package Contents
1of2
Assembly Instruction Sheet #IS-PCLS1722C
For Style PCLS1722C
C
Fixture Body
x1
Crossbar
x1
A
Mounting Screw
x2
B
Pleasegoto forproductcleaningtips.Gotothe selection.
Flatheadscrewdriver,Phillipsscrewdriver,pliers,wirecutters,wirestrippers,electricaltape,safetyglasses.
IntegratedLED22W
www.quoizel.com Care+Maintenance
ToolsRequired:
LightSource:
EstimatedAssemblyTime:
Preparation:
20-30minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtobesureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactcustomerserviceforreplacement
parts.
CompatibleDimmerSwitches:LutronDVELV-300PorLutronSELV-300P.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-800-645-3184
or visit us on-line at www.quoizel.com
2017 QuoizelInc.
G
ND
2.4mm
13 Ga13 Ga
STEP 1 - Adjust Lamp Tube
A. By holding the metal part of the lamp tube, carefully rotate lamp
tubes anti-clockwise to your desired directions.
Note: The shortest lamp tube against the ceiling canopy is the fixed
lamp tube, which cannot be rotated.
ReleasedDate:2017-08-25
Fixed Lamp Tube
(Shortest one against
the ceiling canopy)
Fixed Lamp Tube
(Shortest one against
the ceiling canopy)
FRONT VIEW
BOTTOM VIEW
Figure 1
ROTATE
ROTATE
ROTATE
ROTATE
Metal
STEP 2 Attach Crossbar to Outlet
Box
-
A. Attach the Crossbar (A) to Outlet
Box and secure by threading Outlet
Box Screws (not supplied) into the
Mounting Holes on the Outlet Box.
Tighten until snug.
A
Figure 2
Outlet
Box
Outlet Box
Screw
STEP 4 - Attach Ceiling Canopy to Crossbar
A. Line up the holes on the side of the ceiling canopy to the mounting
holes on the Crossbar (A). Secure them with Mounting Screws (B).
Tighten until sung.
Your fixture is now assembled and ready to use. Enjoy!
A
B
Figure 4
Ceiling
Canopy
STEP 3 - Wire Connections
A. Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
B. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
Figure 3
Green Ground Screw
on the Crossbar
White wire
from outlet box
White wire
from fixture
Black wire from
outlet box (or Red)
Black wire
from fixture
Bare, or Green
Ground wire
from outlet box
Ground wire
from Fixture