Installation Sheet

2of2
2018 QuoizelInc.
ReleasedDate:2018-08-10
visit us on-line at www.quoizel.com
STEP 4 Attach Ceiling Canopy to Inner Backplate-
A. Fit excess cord and electrical wires in the ceiling canopy and
Fixture Body (G) properly. Line up the holes on the side of the ceiling
canopy to the mounting holes on the Inner Backplate (A). Secure
them with Mounting Screws (B). Tighten until sung.
B
A
Figure 4
STEP 6 Install Crystals-
A. Remove the lock screw with hangtag from the Fixture Body (G).
B. Place the Crystal (F) onto the Fixture Body (G) from the gap where
the lock screw removed. Press the tab on the Crystal (F) into the slot
on the ring and move the Crystal (F) along the ring.
C. Install total 39 Crystals (F) onto the Fixture Body (G) one by one.
D. Remove the hangtag from the lock screw and thread the lock screw
back into the gap of the ring.
Your fixture is now assembled and ready to use. Enjoy!
F
Slot
G
Move
Figure 6
Tab
Move
Gap
Mounting Hole
PCEO1618C
FINISH: POLISHED CHROME
NOTE: ALL DIMENSIONS ARE ROUNDED UP
TO THE NEAREST 1/4"
G
G
N
D
15.75” Dia.
17.75” Dia.
4.5”
Remove to install
crystals
a
nd reinstall
when finish
Remove to install
crystals
a
nd reinstall
when finish
G
Lock Screw
with Hangtag