Installation Sheet

ManualsBrandsQuoizel ManualsCeiling FixturesQuoizel Divine Single Light 14" Wide Integrated LED Flush Mount Ceiling Fixture

Package Contents

1of3

For Style PCDV1616C

Pleasegoto forproductcleaningtips.Gotothe selection.

markingpen,1/4”

drillbitanddrill.

IntegratedLED20W.

20-30minutes

Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtoensureallpartsare

present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactyouroriginalplaceofpurchase.

www.quoizel.com Care+Maintenance

LightSource:

EstimatedAssemblyTime:

Preparation:

ToolsRequired: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses,

Installation Guide #IS-PCDV1616C

2019 QuoizelInc.

ReleasedDate:2019-01-03

visit us on-line at www.quoizel.com

Warnings and Cautions

Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.

These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly

recommend that a licensed, professional electrician perform the installation.

Inner Backplate

Mounting Screw

Support Rod

Lock Screw

Crystal

(2 free replacement

crystals are included)

x44

Diffuser

Wall Anchor

Screw

Washer

Fixture Body

Bottom Plate

STEP 1 Install Support Rods-

A. Thread Support Rods (H) onto the bolts on the Bottom Plate (K) and

hand tighten until snug.

Figure 1

STEP 2 Install Diffuser-

A. Remove lock nuts and tabs from the Bottom Plate (K).

B. Place the Diffuser (I) onto the Bottom Plate (K) with the crystal beads

are on the top.

C. Place the previously removed tabs back onto the Bottom Plate (K)

and the Diffuser (I). Thread the previously removed lock nuts back to

secure the Diffuser (I). Hand tighten gently until snug.

Lock Nut

Tab

Crystal Beads

Figure 2

Summary of content (3 pages)

PAGE 1
Installation Guide #IS-PCDV1616C For Style PCDV1616C Please go to www.quoizel.com for product cleaning tips. Go to the Care + Maintenance selection. Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses, marking pen, 1/4” drill bit and drill. Light Source: Integrated LED 20W. Estimated Assembly Time: 20-30 minutes Preparation: Identify and inspect all parts before beginning installation.
PAGE 2
STEP 3 - Install the Fixture Body to Support Rods STEP 6 - Wire Connections A. Place the Fixture Body (G) onto Support Rods (H) and align holes on the float plate to Support Rods (H). Secure the Fixture Body (G) by using Lock Screws (F). Hand tighten until snug. A. Wrap bare or green ground wire around green ground screw on the crossbar, no less than 2 inches from the end of the wire. Tighten the green ground screw. B. Use standard wire connectors (not included) to make all wire connections.
PAGE 3
PCDV1616C 11.75” Dia. FINISH: POLISHED CHROME 3.25” 14” Dia. G ND NOTE: ALL DIMENSIONS ARE ROUNDED UP TO THE NEAREST 1/4" 2019 QuoizelInc. visit us on-line at www.quoizel.