Installation Sheet

Pleasegoto forproductcleaningtips.Gotothe selection.
(2)A19MediumBaseBulbs60WMaximum,bulbsnotincluded.
20-30minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtobesureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactyouroriginalplaceofpurchase.
www.quoizel.com Care+Maintenance
LightSource:
Estimated Assembly Time:
Preparation:
ToolsRequired:None.
Warnings and Cautions
1of1
Installation Guide #IS-MC4048WT
For Style MC4048WT
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
Bulb (not
included)
MC4048WT
NOTE: ALL DIMENSIONS ARE ROUNDED
UP TO THE NEAREST 1/4"
Base
x1
16” Dia.
24.75”
Cord
FINISH: WESTERN BRONZE
2018 QuoizelInc.
ReleasedDate:2018-08-08
visit us on-line at www.quoizel.com
Finial
x1
Shade
x1
Flat Washer
x1
Big Knurled Nut
x1
Small
Knurled Nut
x1
Check Ring
x1
Spacer Tube
x1
Nipple with
Hex Nut
x1
Rubber
Washer
x1
5.75”
A. Thread the hex nut end of the Nipple with Hex Nut into the hex
coupling on the top center of the Socket Assembly. By using the
pliers, thread the hex nut against the hex coupling and hand tighten
until snug.
B. Place the Spacer Tube and the Check Ring over the top end of the
Nipple and secure with the Small Knurled Nut. Hand tighten until
snug.
Diffuser
x1
(Sandblasted Side)
C. Thread the Big Knurled Nut
onto the top end of the
Nipple and adjust it to
proper location for rest
components. Place the Flat
Washer, the Shade, the
Diffuser and the Rubber
Washer over the top end of
the Nipple as shown. Make
sure the sandblasted side of
the Diffuser is downward.
Secure with the Finial and
hand tighten until snug.
D. Insert bulbs onto sockets
and screw snugly into place.
Your fixture is now
assembled and ready to
use. Enjoy!
12.25” Dia.
7” Dia.