Installation Guide

4
CARE AND MAINTENANCE
Wipe clean using soft, dry cloth or static duster. Always avoid using harsh chemicals and abrasives to clean
fixture as they may damage the finish.
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
Bulbs will not light.
Fuse blows or the
circuit breaker trips
when light is turned
on.
1. Bulb is burned out.
2. Power is off.
3. Faulty wire connection.
4. Faulty switch.
Crossed wires or power wire is
grounding out.
1 . Replace light bulb.
2. Make sure power supply is on.
3. Check wiring.
4. Test or replace the switch.
Check wire connection.
STEP 6:
a. Make sure the surface of the exterior wall and fixture
backplate are free of dirt.
b. Using silicone sealer (not included) start on one side of
fixture backplate and follow contour where the fixture
backplate meets the exterior wall surface.
c. Proceed to seal around backplate.
To ensure proper moisture drainage, do not seal
bottom of fixture backplate.
NOTE:
Silicone Sealer
Exterior Wall Surface
Fixture Backplate
Your installation is now complete! Restore electricity
and save this sheet for future reference.
Glass Holder Screw
Fixture hood
Glass Frame
Glass Frame Screw
Glass Holder
Glass Replacement
a. Remove glass frame from fixture body by removing
glass frame screws at the top of the Fixture body.
b. Remove the glass holder at the top of the glass frame
by removing the four glass holder screws.
c. Replace glass panels from the fixture body and then
re-install the glass holder. Secure with removed glass
holder screws.
d. Attach the glass frame back onto the fixture body and
secure with glass frame screws.
Glass Panels
2018 QuoizelInc.
Printed in China