Installation Guide

3
STEP 2:
a. Remove mounting balls from the crossbar assembly.
b. Fit the backplate to the crossbar assembly and secure
with mounting balls.
The backplate should be snug against the wall and
the mounting balls.
- If not, adjust the length of the mounting screw on the
crossbar assembly by unscrewing the preassembled
hex nut.
- Then screw the mounting screws in or out of the
crossbar until the correct length is achieved.
- Once the backplate is secure, remove the mounting
balls and backplate and proceed to step 3.
Note:
Crossbar Assembly
Outlet Box Screw
Outlet Box
STEP 1:
a. Secure the crossbar to the outlet box (not included) with
outlet box screws.
b. Tighten until snug.
: Place a cloth or towel on the ground under the
work area to prevent loss of mounting hardware if
dropped.
The preassembled mounting screws on the
crossbar should protrude outward.
Note
Note:
Mounting Screw
Hex Nut
Mounting Ball
Backplate
STEP 4:
a. Re-attach the backplate of the fixture body to the
crossbar assembly.
b. Secure with the previously removed mounting balls.
Mounting Screw
Mounting Ball
Backplate
STEP 5:
a. Install correct bulbs referring to fixture markings and/or labels for maximum wattage.
WHITE
BLACK (OR RED) WIRE
WHITE
BLACK
FROM SUPPLY
FROM SUPPLY
FROM FIXTURE
FROM FIXTURE
STEP 3:
* Use Wire Connectors (supplied) to connect the
wires.
a) Ground Wire:
1. Wrap supply around
on mounting bracket, no less than 2 in. from the end of
the wire. Tighten .
2. Connect fixture to wire
with wire connector.
b) Supply Wire:
1. Connect the to the
with wire connector.
2. Connect the wire to the
with wire connector.
3. Wrap each connection with approved electrical tape
and carefully stuff all of the connected wires into the
outlet box.
ground wire green ground screw
ground screw
ground wire supply ground
supply white wire white fixture
supply wire
supply black (or red) black
fixture supply wire
GROUND WIRE
GROUND WIRE
FROM SUPPLY
FROM FIXTURE
GREEN GROUND SCREW
2018 QuoizelInc.