Installation Sheet
3of4
2017 QuoizelInc.
ReleasedDate:2017-02-07
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-800-645-3184
or visit us on-line at www.quoizel.com
STEP 1B Install the Crossbar to the junction box-
.
A. Attach the Crossbar (AA) to the Outlet Box with the head of the
Green Ground Screw facing you. Secure it with Outlet Box Screws
(not included), tighten until snug
Outlet Box
Outlet Box Screw
(not included)
Green Ground
Screw
AA
Figure 1B
STEP 2B Install the Nipple to the Crossbar-
A. Thread the Hex Nut (CC) to the middle of the Nipple (DD). Place the
Lock Washer (BB) over the Nipple (DD) and then thread the Nipple
(DD) into the Crossbar (AA) until the Nipple (DD) is about 0.375”
above the Crossbar (AA).
B. Place the ceiling canopy and Fixture Body (A) over the end of the
Nipple (DD) against the ceiling to determine the correct position of
the Nipple (DD). Thread the Lock Ball (FF) onto the Nipple (DD).
Adjust the Nipple (DD) to allow the ceiling canopy to rest against the
ceiling when held in place by the Lock Ball (FF).
C. Remove the Lock Ball (FF) and the Fixture Body (E). Tighten the
Hex Nut (CC) against the Crossbar (AA) to secure in place.
DD
BB
CC
E
FF
Figure 2B
Figure 3B
STEP 4B Install Fixture Body to Ceiling-
A. Attach the ceiling canopy and Fixture Body (E) over the end of the
Nipple (DD) and secure with Knurled Nut (EE). Hand tighten until
snug.
B. Thread the Lock Nut (FF) onto the end of the Nipple (DD) and hand
tighten until snug.
E
DD
EE
FF
Figure 4B
STEP 5B - Install Bulbs
A. Insert bulbs onto sockets and screw snugly into place.
Your fixture is now assembled and ready to use. Enjoy!
Socket
Vintage Bulb
(recommended
but not supplied)
Figure 5B
STEP 3B - Making the Wire Connections
A. Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into outlet box.
Note: If the electrical wire is going to be cut shorter than provided
you will need to identify the "L" line wire and the "N" neutral wire
before you cut the excess wire off. One is labeled N and the other
labeled L. To do this separate the "L" line wire and the "N" neutral
wire as far as you need to. Re-label the wire near where you want to
make the cut. Be sure to mark the wire on the side of the fixture and
not on the excess wire being cut and removed.
B.
Green Ground Screw
on the Crossbar
White wire
from outlet box
White wire from fixture
identified with the Label “N”
Black wire from
outlet box (or Red)
Black wire from fixture
identified with the label “L”
Bare, or Green
Ground wire
from outlet box
Ground wire
from Fixture