Installation Sheet

2of2
2018 QuoizelInc.
ReleasedDate:2018-09-18
visit us on-line at www.quoizel.com
STEP 6 Install Fixture
Body to Crossbar
Assembly
-
A. Attach the backplate and
the Fixture Body (I) over
the end of the nipple and
secure with previously
removed mounting ball.
Hand tighten until snug.
STEP 4 - Install the Crossbar Assembly to Outlet Box and Adjust
the length of the Nipple
A. Attach the Crossbar Assembly (A) to the Outlet Box with the head of
the Green Ground Screw facing you. Secure it with Outlet Box
Screws (not included), tighten until snug
B. Adjust the hex nut and lock washer underside of the crossbar to the
middle of the nipple.
C. Remove the mounting ball from the nipple. Place the backplate and
the Fixture Body (I) over the nipple against the wall to determine the
correct position of the nipple. Thread the mounting ball onto the
nipple. Adjust the nipple to allow the backplate and the Fixture Body
(I) to rest against the wall when held in place by the mounting ball.
D. Remove the mounting ball and the Fixture Body (I). Tighten the lock
washer and the hex nut against the crossbar to secure in place.
.
STEP 5 - Wire Connections
A. Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
B. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
Green Ground Screw
on the Crossbar
White wire
from outlet box
White wire
from fixture
Black wire from
outlet box (or Red)
Black wire
from fixture
Bare, or Green
Ground wire
from outlet box
Ground wire
from Fixture
Figure 4
A
Nipple
Mounting
Ball
I
Figure 5
Backplate
Outlet Box
STEP 7 Install Bulbs and
Fixture Hood
-
A. Insert bulbs onto sockets and
screw snugly into place.
B. Attach the Fixture Hood (H)
onto the Fixture Body (I) and
secure with Lock Screws B (C).
Hand tighten until snug with
screwdrivers.
Figure 6
STEP 8 - Apply Silicone Sealer
A. Make sure the exterior wall
surface and fixture backplate
are free of dirt before applying
caulk. Using exterior grade
caulk, caulk over top of
backplate and down both sides.
Do not caulk the bottom of the
fixture backplate to ensure
proper moisture drainage.
Your fixture is now assembled
and ready to use. Enjoy!
Exterior
Grade Caulk
Exterior
Grade Caulk
Backplate
Figure 8
I
Bulb (not
included)
Socket
C
A
Hex Nut and
Lock Washer
Nipple
Mounting Ball
I
Outlet Box Screw
(not included)
Outlet Box
Green Ground Screw
Backplate
Figure 7
H
BRS8409AGV
FINISH: AGED VERDE
22.75”
17.25”
6.5”
9”
6.5”
9”
NOTE: ALL DIMENSIONS ARE ROUNDED
UP TO THE NEAREST 1/4"