Installation Guide

2of2
2017 QuoizelInc.
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-800-645-3184
or visit us on-line at www.quoizel.com
ReleasedDate:2017-03-09
STEP 8 - Wire Connections
A. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
White wire
from outlet box
White wire
from fixture
Black wire from
outlet box (or Red)
Black wire
from fixture
Bare, or Green
Ground wire
from outlet box
Ground wire
from fixture
Bare, or Green
Ground wire
from outlet box
OR
Ground wire
from fixture
Green Ground Screw
on the Crossbar
Figure 8
G
ND
BRE8407K
FINISH: MYSTIC BLACK
NOTE: ALL DIMENSIONS ARE ROUNDED UP
TO THE NEAREST 1/4"
7”
7”
4.5”
8”
5.5”
11.5”
Fixture can
only be
mounted in
the direction
indicated
STEP 6 Installing the Crossbar Assembly-
A. Pass the supply wires through the Crossbar Assembly (A). Attach
the Crossbar Assembly (A) to the Outlet Box with the head of the
Green Ground Screw facing you. Secure the Crossbar Assembly (A)
with Outlet Box Screws (not included). Tighten until snug
Note: Use the Alternate Shorter Mounting Screw (B) if your
installation requires a shorter mounting screw.
.
Outlet Box Screws
(not included)
Outlet
Box
Mounting Screw
or Alternate Short
Mounting Screw
STEP 7 Test Fit the Backplate to the Crossbar Assembly-
A. Remove the mounting balls from the Crossbar Assembly (A). Place
the backplate and Fixture Body (C) onto the Crossbar Assembly (A)
and secure with mounting balls. Note: The backplate and Fixture
Body (C) should be snug against the wall and held tight with the
mounting balls. If it is not, adjust the length of the mounting screw
or alternate short mounting screw on the Crossbar Assembly (A) by
unscrewing the preassembled hex nut and lock washer and then
screwing the mounting screws or alternate short mounting screws
in or out of the crossbar until the correct length is achieved. Once
the backplate and Fixture Body (C) is secure, remove the mounting
ball and Fixture Body (C) and proceed to Step 8.
C
Mounting Ball
A
Backplate
Hex Nut and
Lock Washer
Mounting Screw
or Alternate Short
Mounting Screw
Supply Wires
with Ground Wire
A
Figure 6
Figure 7
STEP 9 Install the Fixture
Body
-
A. Position the backplate and
Fixture Body (C) onto the
Crossbar Assembly (A).
Place the holes in the
backplate over the
mounting screws or
alternate short mounting
screws. Secure the
Fixture Body by using the
mounting balls and hand
tighten the mounting balls
until snug.
C
Mounting Ball
A
Backplate
Mounting Screw
or Alternate Short
Mounting Screw
STEP 10 Apply Silicone Sealer-
A. Make sure the exterior wall
surface and fixture backplate are
free of dirt before applying caulk.
Using exterior grade caulk, caulk
over top of backplate and down
both sides. Do not caulk the
bottom of the fixture backplate to
ensure proper moisture drainage.
Your fixture is now assembled
and ready to use. Enjoy!
Exterior
Grade Caulk
Backplate
Exterior
Grade
Caulk
Figure 9
Figure 10