Installation Guide

2of2
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
or visit us on-line at www.quoizel.com
2015 QuoizelInc.
August2015
STEP 4 - Install Fixture Chain and
Ceiling Canopy
A. Pull the supply wires through the
Canopy Lock Ring (FF) and the
Ceiling Canopy (HH) in order.
B. Connect the Fixture Loop (A) to
Canopy Chain Loop (EE) by using
the Quick Link (GG). The fixture will
hang safety now. Close the Quick
Link (GG).
C. Feed the Supply Wires and Ground
Wire through the Canopy Chain Loop
(EE) and Nipple (DD) into the Outlet
Box. Cut the wires leaving
approximately 8” of wire extending
from the Outlet Box.
D. Refer to Step 5 for wire connections.
E. Raise the Ceiling Canopy (HH) and
Canopy Lock Ring (FF) up the Quick
Link (GG) and over the Canopy
Chain Loop (EE). Tighten the
Canopy Lock Ring (FF) onto the
Canopy Chain Loop (EE) until tight.
STEP 6 Install Shade and Bulb-
A. Place Shade (D) over the
Candle Cover properly.
B. This fixture uses candelabra
bulb with screw base.
Maximum 60 watts. Insert bulb
and screw snugly into place.
Your fixture is now assembled
and ready to use. Enjoy!
Figure 5
STEP 5 - Wire Connections
A. Use standard wire connectors (not included) to make all wire
connections. (Connectors are not included with fixture.) Twist
connectors until wires are tightly joined together. Wrap each
connection with approved electrical tape and carefully stuff all the
connected wires into outlet box.
Note: If the electrical wire is going to be cut shorter than provided
you will need to identify the "L" line wire and the "N" neutral wire
before you cut the excess wire off. One is labeled N and the other
labeled L. To do this separate the "L" line wire and the "N" neutral
wire as far as you need to. Re-label the wire near where you want to
make the cut. Be sure to mark the wire on the side of the fixture and
not on the excess wire being cut and removed.
White wire
from supply
Ribbed side of wire from fixture
identified with the Label “N”
Black wire from
supply (or Red)
Smooth side of wire from fixture
identified with the label “L”
Ground wire
from supply
Ground wire
from fixture
ADA5009LN
FINISH: LEATHERED BRONZE
PART NUMBER REPLACEMENT PART
QTY.
NO.
1
2
2
9012EXLN
12”L ROD
3
9006EXLN
6”L ROD
2
2
1
NOTE: ALL DIMENSIONS ARE ROUNDED UP
TO THE NEAREST 1/4"
S12239WL SHADE
9
D
Candle
Cover
Bulb
55.5” OVERALL
HEIGHT (2) 6” AND
(2) 12” RODS
INCLUDED
5” Dia.
(9) 60W Candelabra
Bulbs
(Not Supplied)
Base
Figure 6
1”
19.5”
5.5” Dia.
5
29.25” Dia.
3
DD
Supply
Wires and
Ground Wire
EE
A
FF
GG
HH
Figure 4