User's Manual

4
Operation
• The LED will stay off during the normal operation.
• The sensor is equipped with a tamper switch. If the cover of sensor is removed, the sensor will send
an alarm to the ZigBee coordinator. The sensor will be in "Awake" mode before replacing the cover.
Reset to Factory Defaults
A security sensor should be able to be manually defaulted from the device by putting it into a state where
it is ready to be paired to a CPE. The process shall be as follows:
• Depress the tamper switch after removing the battery from the sensor.
• Insert the battery. The sensor should illuminate the LED once all bootup/initialization tasks are
complete
• Release the tamper switch while the LED is illuminated (4 seconds)
The sensor should then reset to default and begin searching for a new network