User's Manual


INSTALLATION
Outlink should be
installed by a qualified
electrician and used
in accordance with
appropriate electrical
codes and regulations.
1 Turn OFF power at
the circuit breaker that
controls the outlet. It
is recommended to use
a circuit tester to make
sure the circuit is off.
2 Remove existing wall
plate and outlet.
3 Disconnect the wiring
from the existing outlet.
4 Connect Outlink assembly
wiring with included
push-in wire connectors.
A push-in wire connector
works as a ‘finger trap’
for wires; simply push
wires into an available
pole to lock.
