Information

Enter Setup
Read Barcode On/Off
Sending the Read Barcode Off command ~<SOH>0000#SCNENA0;<ETX> to the engine can disable it from reading barcode,
and the engine is unable to scan barcode unless you send the Read Barcode On command
~<SOH>0000#SCNENA1;<ETX> to it or power cycle it. By default, Read Barcode is On.
Scanning Preference
Normal Mode: Select this mode when reading barcodes on paper.
Screen Mode: Select this mode when reading barcodes on the screen.
High Motion Tolerance Mode: Select this mode when reading barcodes on moving objects.
** Normal Mode
Screen Mode
Decode Area
Whole Area Decoding: The engine attempts to decode barcode(s) within its field of view, from the center to the periphery, and
transmits the barcode that has been first decoded.
Specific Area Decoding: The engine attempts to read barcode(s) within a specified decoding area and transmits the barcode
that has been first decoded. This option allows the engine to narrow its field of view to make sure it reads only those barcodes
intended by the user. For instance, if multiple barcodes are placed closely together, specific area decoding in conjunction with
appropriate pre-defined decoding area will insure that only the desired barcode is read.
Acuread Decoding: The engine only decodes the barcode aimed squarely by the aiming pattern. For those using a crosshair
aiming pattern, only the barcode aimed by the center of crosshair will be decoded.
** Exit Setup
39