Information

Enter Setup

Trigger Commands

When Enable Trigger Commands is selected, you can activate and deactivate the engine in the Level mode with serial trigger

commands. Sending the Start Scanning command (default: <SOH> T <EOT>, user-programmable) to the engine in the Level

mode activates a decode session. The decode session continues until a barcode is decoded or the decode session timeout

expires or the engine receives the Stop Scanning command (default: <SOH> P <EOT>, user- programmable).

** Disable Trigger Commands

Enable Trigger Commands

Modify Start Scanning Command

The Start Scanning command can consist of 1-10 characters (HEX values from 0x01 to 0xFF). In this command, the character

“?” (HEX: 0x3F) cannot be the first character. The default Start Scanning command is <SOH> T <EOT>.

Modify Start Scanning Command

Set the Start Scanning command to “*T”:

1. Scan the Enter Setup barcode.

2. Scan the Modify Start Scanning Commandbarcode.

3. Scan the numeric barcodes “2”, “A”, “5” and “4” from the “Digit Barcodes” section in Appendix.

4. Scan the Save barcode from the “Save/Cancel Barcodes” section in Appendix.

5. Scan the Exit Setup barcode.

** Exit Setup