Information

Enter Setup
Good Read Delay
Good Read Delay sets the minimum amount of time before the engine can read another barcode. This parameter is
programmable in 1ms increments from 1ms to 3,600,000ms. The default setting is 500ms. Scan the appropriate barcode below
to enable or disable the delay.
Enable Good Read Delay
** Disable Good Read Delay
To set the good read delay, scan the barcode below, then set the delay (from 1 to 3,600,000ms) by scanning the digit barcode(s)
then scanning the Save barcode from the Appendix.
Good Read Delay
Set the good read delay to 1,000ms:
1. Scan the Enter Setup barcode.
2. Scan the Good Read Delay barcode.
3. Scan the numeric barcodes “1”, “0”, “0” and “0” from the “Digit Barcodes” section inAppendix.
4. Scan the Save barcode from the “Save/Cancel Barcodes” section in Appendix.
5. Scan the Exit Setup barcode.
** Exit Setup
32