Information

Enter Setup
Image Stabilization Timeout (Sense Mode)
This parameter defines the amount of time the enginer will spend adapting to ambient environment after it decodes a barcode
and “looks” for another. It is programmable in 1ms increments from 0ms to 3,000ms. The default setting is 500ms.
Image Stabilization Timeout
Set the image stabilization timeout to 800ms:
1. Scan the Enter Setup barcode.
2. Scan the Image
Stabilization Timeout barcode.
3. Scan the numeric barcodes “8”, “0” and “0” from the “Digit Barcodes” section inAppendix.
4. Scan the Save barcode from the “Save/Cancel Barcodes” section in Appendix.
5. Scan the Exit Setup barcode.
** Exit Setup
29