Information

Factory Defaults Table
Parameter
System Settings
Factory Default Remark
Barcode Programming
Programming Barcode Data
Internal Illumination
Aiming
Disabled (Exit Setup)
Do not transmit
Normal
Normal
Good Read LED On
Good Read LED Duration
Power On Beep
Short (20ms)
On
Good Read Beep On
Good Read Beep Duration
Good Read Beep Frequency
Good Read Beep Volume
Scan Mode
Medium (80ms)
Medium (2730Hz)
Loud
Sense Mode
Decode Session Timeout
Image Stabilization Timeout (Sense Mode)
3,000ms. 1-3,600,000ms; 0: Infinite
0-3,000ms500ms
Disabled
Reread Timeout
50ms 1-3,600,000ms
Reread Timeout Reset
Image Decoding Timeout
Good Read Delay
Off
500ms 1-3000ms
Disabled, 500ms 1-3,600,000ms
Sensitivity Sensitivity 6
Trigger Commands
Start Scanning Command
Stop Scanning Command
Scanning Preference
Read Barcode
Disabled
<SOH> T <EOT>
<SOH> P <EOT>
Normal Mode
On
Decode Area
Whole Area Decoding
Specify Decoding Area
Image Flipping
40% top, 60% bottom, 40% left, 60% right
Do Not Flip
Off
Bad Read Message
NG 1-7 characters
Auto Sleep Disabled
15ms
Time Period from Idle to Sleep
221