Information

Enter Setup
Chapter 8 Batch Programming
Introduction
Batch programming enables users to integrate a batch of commands into a single batch barcode.
Listed below are batch programming rules:
1. Command format: Command + Parameter Value.
2. Each command is terminated by a semicolon (;). Note that there is no space between a command and its terminator
semicolon.
3. Use the barcode generator software to generate a 2D batchbarcode.
Example: Create a batch barcode for internal Illumination Always On, Sense Mode, Decode Session Timeout = 2s:
1. Input the commands:
@ILLSCN2;SCNMOD2;ORTSET2000;
2. Generate a batchbarcode.
When setting up the engine with the above configuration, scan the Enable Batch Barcode barcode and then the batch barcode
generated.
Enable Batch Barcode
** Exit Setup
214