Information

Enter Setup
Set Length Range for GS1-128
The enginecan be configured to only decode GS1-128 barcodeswith lengths thatfall between(inclusive) the minimum and
maximum lengths. Toaccomplish it, you need to set the minimum and maximum lengths.
Set the Minimum Length (Default: 1)
Set the Maximum Length (Default: 48)
If minimum length is set to be greater than maximum length, the engine only decodes GS1-128 barcodes with
either the minimum or maximum length. If minimum length is same as maximum length, only GS1- 128
barcodes with that length are to be decoded.
Set the engine to decode GS1-128 barcodes containing between 8 and 12 characters:
1. Scan the Enter Setup barcode.
2. Scan the Set the Minimum Length barcode.
3. Scan the numeric barcode “8” from the “Digit Barcodes” section in Appendix.
4. Scan the Save barcode from the “Save/Cancel Barcodes” section in Appendix.
5. Scan the Set the Maximum Length barcode.
6. Scan the numeric barcodes “1” and “2” from the “Digit Barcodes” section in Appendix.
7. Scan the Save barcode from the “Save/Cancel Barcodes” section in Appendix.
8. Scan the Exit Setup barcode.
** Exit Setup
133