Instructions

Entering admin operating mode:
Press Master code # factory default:999999
*
Note：All the below operations need be under programming mode.
4
.1 Change the master code：
Press
0
new code #
repeat new master code#
Note: Master Code length:6~8 digits
4
4
.2 Add users by remote control：
.2.1 Read card to add user：
Press
1
read card #
read card ...
#
4
.2.2 Use ID Number to add user：
Press
1
card number # ... card number# ...
#
Note: 1.Card number must be 8 or 10 digits, if the card number is less than 8 or 10 digits, input 0 before the card number
. press confirm，press last finish，press exit。
.2.3 Add consecutive number card.：
press 1 card quantity# 8 or 10 digits card number
2
#
#
*
4
Add consecutive number cards users，card quantity 1-9999，green fast flash。
.3 Delete users via remote control：
4
4
.3.1 Read card to delete user：
press
.3.2 Use card NO. to delete user：
press 8 or 10 digits card number #
.3.3 Delete all users：
press 20000 #
2
read card
read card
…
#
。
4
4
2
8 or 10 digits card number # …
#
.
。
Note：This operation will delete all users，but admin card wont be deleted
.4 Safe mode setting:
4
4
.4.1 Normal mode（factory default）：
press 3
.4.2 Dead mode：
press 3
0
#
。
4
4
1
#
。
read invalid cards 10 times continuously within 10minutes，the device be dead for 10 minutes
.4.3 Alarm mode：
press
3
2
#
。
read invalid cards 10times continuously within 10minutes，Both external alarm and built-in alarm sound.
4
4
.5 Door open time setting：
press
4
0～99
#
。
Note：range“0～99seconds”，0mS equates 50mS。
.6 Alarm time setting：
press
5
0～3
#
。
Note：range“0～3minutes”，factory default 1minute。
.7 Red light mode setting：
4
4
.7.1 Static disable mode：
press 6
.7.2 Static normal mode（factory default）：
press
0
#
。
4
6
1
#
。