Instructions

Port
Output
no
NO. Card dispenser Working States
Buzzer Output
1
2
3
4
5
6
Reset
Consecutive ring "toot, toot"
Interval ring "toot”
Lack card (can dispense card)
Jam card(can’t dispense card)
overtime error(can’t dispense card)
warehouse full (can dispense card)
Empty
Lower
Interval ring "toot, toot”
Interval ring "toot, toot, toot”
Interval ring "toot, toot, toot, toot”
Error
Interval ring "toot, toot, toot, toot, toot” Lower
5. Operation and Maintenance
5.1 installation
The card dispenser is designed to be incorporated within a suitable cabinet mounted.
First make two holes with diameter of 3mm in the ticket box according to the holes on the
soleplate, then fix the soleplate with bolt, nut and gasket to the ticket box, finally put the
machine into the soleplate and fix it. The installation is done. Put the signal cables into the
socket of the machine, turn the power on and check the machine.
5.2 card Loading
In order to fill the cartridge with cards, the following steps must be followed:
Remove power from the unit.
1
2
3
)
)
Remove the card weight form the cartridge.
)
Place a small amount (3cards) over the empty micro-switch in the unit, inuring that the
cards are situated firmly on the surface under the card adjust plate.
Place the remainder of the cards on top of the 3cards that were initially placed in the unit.
Replace the card weight on top of the cards in the unit.
4
5
6
)
)
)
Restore power to the unit.
5.3 cleaning the jams
Should a card jam ever occur, you can clear it by the following precautions:
1
)
Remove power from the unit.
-
10 -