Instructions

NFC & MIFARE & ISO14443AB & ISO15693 & ISO18000 & ISO7816 IC Card Module www.quio-rfid.de
Copyright © 2003-2022 Quick Ohm Küpper & Co. GmbH. All rights reserved. 51/101
5.7.2.2 MIFARE Plus Commit Perso
Function: Level 0 command, to switch Level0 to Level1 or Level3. Target Level depends on
the card. If need switch to Level 1 or Level 3, please tell the suppliers when purchasing. Before
using this command, please use MIFARE Plus Write Perso command to write all AES key and
the initial value of all the blocks, then make the changed data effective.
Host sends:
Frame 0x34 Checksum
Success:
Frame 0x34 Status Checksum
Status: status code returned from the card.
Please reference: MIFARE Plus Returned Status Code.
Failure:
Frame 0xCB Checksum
Example:
Send: 0x00 04 00 34 30
Return: 0x00 04 01 34 31
5.7.2.3 MIFARE Plus Switch to Level2/3
Function: Level 1 or Level 2 command, switch to Level2 or Level3
Host sends:
Frame 0x35 Level Key Checksum
Level: 1 byte, level to be switched, 2: Level 2; 3: Level 3.
Key: 16 bytes.
Success:
Frame 0x35 Status Checksum
Status: status code returned from the card.
Please reference: MIFARE Plus Returned Status Code.
Failure:
Frame 0xCA Checksum
Example:
Send: 0x00 15 00 35 03 FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF 23
Return: 0x00 04 01 35 30
5.7.3 MIFARE Plus Application Layer Commands
5.7.3.1 MIFARE Plus Data Block Authenticate
Function: Level 3 command, authentication for data block.
Host sends:
Frame 0x36 Key Type Address Key Checksum
Key Type: 0: key A; 1: key B
Address: 2 bytes (MSB first).
Key: 16 bytes.
Success: