Instructions

NFC &
MIFARE & ISO14443AB & ISO15693 & ISO18000 & ISO7816 IC Card Module www.quio-rfid.de
Copyright © 2003-2022 Quick Ohm Küpper & Co. GmbH. All rights reserved. 34/101
needs to request card and verify the card support ISO14443-4 via SAK of card. If the automatic
detecting card function is on, after a successful implementation of the RATS command, the
automatic detecting card function will be forced OFF.
Host sends:
Frame 0x30 EN_NADCID Checksum
EN_ NADCID: 1: enable NADCID; 0: disable NADCID (EMV is disable)
Success:
Frame 0x30 ATS Checksum
ATS: ATS, length depends on card.
Failure:
Frame 0xCF Checksum
Example:
Send: 0x00 05 00 30 00 35
Return: 0x00 14 01 30 10 78 80 90 02 20 90 00 00 00 00 00 21 00 41 32 BD
5.4.4 ISO14443-4 TYPE B Request
Function: ISO14443-4 TYPE B card request and set attribute.
Host sends:
Frame 0x60 Mode AFI EN_ NADCID Checksum
Mode: 1 byte, 0: WUPB; 1: REQB; other values: RFU
AFI: 1 byte, the AFI to request, if request all AFI, please use 0x00.
EN_ NADCID: 1: enable NADCID; 0: disable NADCID (EMV is disable)
Success:
Frame 0x60 Info. Checksum
Info: total 13 bytes, 12 bytes of ATQB: 0x50 (1 byte), PUPI (4 bytes), application data
(4 bytes), protocol information (3 bytes), 1 byte answer to Attribute.
For more details, please refer to ISO14443-3 "ATQB Response" part.
Failure:
Frame 0x9F Checksum
Example:
Send: 0x00 07 00 60 00 00 00 67
Return: 0x00 12 01 60 50 18 12 02 23 00 00 00 00 00 00 81 00 00 89
5.4.5 Request Card according to EMV and PBOC
Function: Card Request according to EMV and PBOC standards, and then to set the
communication parameters between the module and card. This card request command is aim to
CPU card (T=CL). It contains ISO14443A&B. After requesting the card via this command, you
could operate the CPU card via sending APDU commands.
Host sends:
Frame 0x32 Checksum
Success: