Instructions

NFC & MIFARE & ISO14443AB & ISO15693 & ISO18000 & ISO7816 IC Card Module www.quio-rfid.de
Copyright © 2003-2022 Quick Ohm Küpper & Co. GmbH. All rights reserved. 28/101
5.2.17 Set Automatic Detecting Card Interval Time
Function: set interval time of automatic detecting card function. The default is 100ms.
Settings will save in the module; it will be not lost after power OFF.
Host sends:
Frame 0x1C Time Checksum
Time: 1 byte, 0x00 to 0xFF, unit is 10mS, 0x01 means 10mS.
Success:
Frame 0x1C Checksum
Failure:
Frame 0xE3 Checksum
Example:
Send: 0x00 05 00 1C 01 18
Return: 0x00 04 01 1C 19
5.2.18 Set the Default of Automatic Detecting Card
Function: Set the default state of automatic detecting card when turned on device. Settings
will save in the module; it will be not lost after power OFF. For temporarily open or close
automatically detect card, please use the 0x11 command.
Host sends:
Frame 0x1D Status Checksum
Status: 1 byte, 0x00: OFF; 0x01: ON, other value: RFU
Success:
Frame 0x1D Checksum
Failure:
Frame 0xE2 Checksum
Example:
Send: 0x00 05 00 1D 01 19
Return: 0x00 04 01 1D 18
5.2.19 Set Default of Automatic Detecting Card and Output SNR
Function: Set default state of automatically detecting card and output SNR when turned on
device. Settings will save in the module; it will be not lost after power OFF.
Host sends:
Frame 0x1E Status Checksum
Status: 1 byte.
Auto request and output UID: BIT0 = 0: OFF; BIT0 = 1: ON
Continuously output UID: BIT1 = 0: OFF; BIT1 = 1: ON
ASCII output format: BIT2 = 0: OFF; BIT2 = 1: ON
Output Communication Protocol Choose: