Instructions

NFC & MIFARE & ISO14443AB & ISO15693 & ISO18000 & ISO7816 IC Card Module www.quio-rfid.de
Copyright © 2003-2022 Quick Ohm Küpper & Co. GmbH. All rights reserved. 21/101
5.2 System commands
5.2.1 Module reset to factory default
Function: Reset all configurations of the module to factory default setting. The new setting
will effect after re-power on. The module will be reset by system watch dog after this command.
Host send:
Frame 0x0F 52 45 53 45 54 Checksum
Success:
Frame 0x0F Checksum
Failure:
Frame 0xF0 Checksum
We use JMY6801H to do the test. Under JCP04 and JCP05 protocols, the report is as
follows:
JCP04 send: 0x07 0F 52 45 53 45 54 5D
JCP04 return: 0x02 0F 0D
In the following commands, we just only use JCP05 protocol as an example.
JCP05 send: 0x00 09 00 0F 52 45 53 45 54 53
JCP05 return: 0x00 04 01 0F 0A
5.2.2 Read product information
Function: read the product information of CURRENT PRODUCT, including product name,
firmware version, firmware date and configuration information.
Host send:
Frame 0x10 Checksum
Success:
Frame 0x10 Information Checksum
Information: 30bytes; 8bytes product name, 4bytes firmware version,8bytes firmware date,
1byte UART baud rate code, 1byte UART Multi-device communication address,1byte I²C
address, 1byte multi-card operation enable status,1byte ISO15693 automatic detecting card
AFI,1byte ISO15693 automatic detecting card AFI enable status, 1byte automatic detecting card
interval,1byte default automatically detecting card status when power on, 1byte default
automatically output SNR set when power on, 1byteRF output power
Failure:
Frame 0xEF Checksum
Example:
Send: 0x00 04 00 10 14
Return: 0x00 22 01 10 4A 4D 59 36 38 30 31 48 34 2E 33 30 32 30 31 33 31 31 32 33 00 01
A0 00 00 00 0A 00 00 00 99