Product guide

P/N 480-0028-00-05 3-12
Chapter 3: Tenor Configuration Manager Wizard
Line Port
If you are configuring an Analog Tenor, the next item to configure is the Line Port Configuration
(see Figure 3-8
).
Figure 3-8 Line Port Configuration
These settings allow you to configure the analog port on the line side. You are prompted to enter the
following information:
• Disconnect Detection - Allows you to set the Tenor to disconnect based on a tone, or battery
removal or reversal.
• Caller ID Detection - Allows you to configure how caller ID is detected.
• Tone Based Answer Detection - Allows you to enable the type of supervision the Tenor can
use to determine more reliably whether or not a call has been answered.
When you are done making changes, click Next again. The Line Port Configuration window shows
your task status as Done. Click Next to advance to the next window.