Product guide

P/N 480-0028-00-05 3-6
Chapter 3: Tenor Configuration Manager Wizard
Select the Application Type
The next few dialogs are displayed only if you are configuring a Digital Tenor. If you are
configuring an Analog Tenor, jump ahead. See “Configure a Multi Path Application” on page 13.
If you are configuring a Digital Tenor, the Application Configuration window appears next. The
Application dialog requires you to select the type of application for which you will be using the
Tenor (see Figure 3-4
).
Figure 3-4 Application Configuration
Select from the following options:
• Multipath - In a Multipath Application, calls originating from a PBX are routed through a
Tenor to the Internet. The call is first attempted as IP, but can fall back to the PSTN if
necessary.
• Gateway - A Gateway Application sends calls out only as IP, with no fallback to the PSTN.
• Termination - A Termination Application receives incoming IP calls, and terminates them to
the PSTN.
When you have made your choice, click Next again. The Application Configuration window shows
your task status as Done. Click Next to advance to the next window.