Operation Manual

- GB-4 -

1. Lid;

2. Case;

3. Control panel with LED display & buons;

4. Handle (2x);

5. Connecon for 12/24V DC;

6. Connecon for 230V AC

OPERATION

All operang elements necessary to use this unit are gathered together into a single operator

panel in the upper part of the cooler.

7. Main switch for turning the unit on and o.

8. Selector switch for full cooling performance at maximum power consumpon

(“TURBO”) or energy-ecient operaon at reduced cooling performance.

9. Digital display of the desired/actual temperature.

10. Pre-select buon for seng the desired cooling temperature or raising the

temperature seng in increments of 1° C.

11. Pre-select buon for seng the desired cooling temperature or lowering the

temperature seng in increments of 1° C.

Aer the cooler has been set up, connected and switched on, the digital display will indicate

the measured temperature in the cooler (e.g. 20°). You can now use the pre-select buons

to set the desired temperature in increments of 1° by pressing the minus or plus buon

repeatedly unl the digital display shows the desired cooler temperature (e.g. -12°). If

you now release the pressed buon, the pre-set value will be conrmed by blinking in the

display. Thereaer, the display will again show the actual temperature inside the cooler and

the box will refrigerate the cool-space unl the desired temperature has been reached. The

cool-space has zones with slightly diering temperatures. The display always reects an

approximate average temperature.

Operate the unit in TURBO mode for parcularly low pre-select temperatures (under –12°

C) or to rapidly cool your refrigerated items. This will increase the cooling performance of

the unit.

Memory funcon: The cooler’s electronics stores the last-set cooling temperature. If the

cooler is switched o and then at some later me switched on again (without seng a new

temperature), the box will “remember” the last preset temperature and automacally use

this seng.

9 10